Sunmach Equipments

FEATURES: 

¨ INPUT-OUTPUT Galvanic Isolation by in built Isolation Transformer

¨ High efficiency hence lesser running costs.

Full wave Full controlled bridge technology to ensure better regulation and fine control over adjustments

¨ Fast response to line and load Variation & Excellent line - load regulation

¨ Can feed directly any type of critical Dc Instruments, machines connected at the Output.

Soft start circuitry to limit inrush current from Incoming Supply

¨ Load fully protected from High output Voltage & facility to have Temperature Compensated Charging

¨ Easy to install and maintain

FEATURES:

¨ INPUT-OUTPUT Galvanic Isolation by in built Isolation Transformer

¨ High efficiency hence lesser running costs.

Full wave Full controlled bridge technology to ensure better regulation and fine control over adjustments

¨ Fast response to line and load Variation & Excellent line - load regulation

¨ Can feed directly any type of critical Dc Instruments, machines connected at the Output.

Soft start circuitry to limit inrush current from Incoming Supply

¨ Load fully protected from High output Voltage & facility to have Temperature Compensated Charging

¨ Easy to install and maintain

• CV / CC Dual Output DC Power Supplies
• FEATURES
• Output Voltage Adjustable From 0 to Specified Voltage
• Current Limit Adjustable fROM 5% to 110% of Specified Load Current
• Two Completely Isolated Outputs can be configured in Series or Parallel to Enhance Voltage or Current Output Capacity Respectively
• Regulation
• Voltage - CV Load & Line ± 0.01% Max
• Current - CC Load & Line ± 0.05% Max
• Ripple - 1mV rms max. 20Hz to 20MHz
• Protection - Overload & Short Circuit
• Externally Programmable Output Voltage
• Remote - Sensing for Distantly Situated Loads
• Metering - 3 Digit DPM to indicate O/P Voltage & Current Separately
  Input Voltage - 230 V AC ± 10% 50HZ Single Phase 
  Operating Temperature - 0 – 50°C
• Input Voltage - 230 V AC ± 10% 50HZ Single Phase 
• Operating Temperature - 0 – 50°C

Programmable with RS232 / RS485 

Power Supply shall be Operated & Control from your PLC / PID

Programmable with RS232/RS485

Power supply shall be operated & Control from your PLC/PID

DC power Supply, Forced Air cooled, combination of Main step-down Transformer, Thyristor with controller, Control panel for measurement & indications. Suitable for indoor use up to a max. ambient Temp. of 10 to 45 Deg. Cent. and humidity 95% RH max.

¨ INPUT-OUTPUT Galvanic Isolation by in built Isolation Transformer

¨ High efficiency hence lesser running costs.

Full wave Full controlled bridge technology to ensure better regulation and fine control over adjustments

¨ Fast response to line and load Variation & Excellent line - load regulation

¨ Can feed directly any type of critical Dc Instruments, machines connected at the Output.

Soft start circuitry to limit inrush current from Incoming Supply

¨ Load fully protected from High output Voltage & facility to have Temperature Compensated Charging

¨ Easy to install and maintain

• 300W to 1280W different combination
• High current density.
• 19" rack adaptable -3U high
• Remote sensing.
• Front panel potentiometer to set V&I
• 3Digit seven segment display for V&I
• High stability and close regulation
• Phase controlled preregulation plus linear post regulation

• Low Cost General Purpose Laboratory Bench Unit.
• Fully Protected Against Overload and Short Circuit.
• Three Independent Outputs Electrically Isolated from Each Other.
• 5V/5A with Over Voltage Crowbar Protection for Digital ICs.
• Electrically Floating Outputs up to 500V DC w.r.t. ground.
• Compact Modular Construction.
• Precise Regulation, Low Ripple and Noise for Both Constant Voltage and Constant Current Operation.
• Quality Components and Conservating Ratings for High Reliability

• Specially Designed for OEM Use Battery Eliminator / Float Charger.
• Output Voltage Adjustability ±10%.
• Quality Components and Conservative Ratings for High Reliability
• and Long Life.
• High Regulation, Low Ripple and Noise.
• Suitable for Bench / Rack Use.

• 300W to 1280W different combination
• High current density.
• 19" rack adaptable -3U high
• Remote sensing.
• Front panel potentiometer to set V&I
• 3Digit seven segment display for V&I
• High stability and close regulation
• Phase controlled preregulation plus linear post regulation